Installation Owner's manual

ManualsBrandsPeerless-AV ManualsHardwareDSX200

1 of 5

ISSUED: 01-05-10 SHEET #: 125-9094-3 03-01-10

Installation and Assembly:

Shelf Bracket for Media Device

Secure two adjustment brackets (D) to shelf (A) using four 1/4-20 x 1/2 round phillips screws (G).

Model: DSX200

C D

E F

High Shelf Position

Low Shelf Position

Description Qty. Part #

shelf 1 124-1941

right vertical support 1 124-1944

left vertical support 1 124-1943

adjustment bracket 2 124-1945

M5 x 16 phillips screw 8 520-1189

M5 x 25 mm phillips screw 2 520-9543

1/4-20 x 1/2 round phillips screw 4 510-9108

safety belt 1 170-8039-1

Parts List

USE BACK MOUNTING HOLES

Summary of content (5 pages)

PAGE 1
Installation and Assembly: Shelf Bracket for Media Device Model: DSX200 A Parts List A B C D E F G H Description shelf right vertical support left vertical support adjustment bracket M5 x 16 phillips screw M5 x 25 mm phillips screw 1/4-20 x 1/2 round phillips screw safety belt C Qty. 1 1 1 2 8 2 4 1 Part # 124-1941 124-1944 124-1943 124-1945 520-1189 520-9543 510-9108 170-8039-1 D E B F G H 1 Secure two adjustment brackets (D) to shelf (A) using four 1/4-20 x 1/2 round phillips screws (G).
PAGE 2
Attaching to Wall Plate 2 Hook right and left vertical supports (B and C) onto wall plate (not supplied) and secure using two M5 x 25 mm phillips screws (F). NOTE: Don’t fully tighten M5 x 25 mm phillips screws (F) until after Step 3 Wall Plate (Not supplied) C B F 3 Secure adjustment brackets (D) to right and left vertical supports (B and C) using eight M5 x 16 mm phillips screws (E). Position right and left vertical supports (B and C) in desired location then tighten M5 x 25 mm phillips screws (F).
PAGE 3
Attaching Safety Belt 4 Select slot in tray as shown in fig 4.1. Remove backing and attach one clear strip through slot and around edge of tray as shown in fig. 4.2. Repeat for other slot on other side of tray. NOTE: This material prevents fraying or cutting of the belt. Fig. 4.2 Fig. 4.1 5 CLEAR STRIPS SLOT FRONT LIP Take one belt and hold it so that the tri-bar belt clip is facing as illustrated. Feed belt up through the slot you have chosen. Remember, belt only goes through outside slot.
PAGE 4
Pull end of safety belt (H) out of bottom buckle slot and back down through top buckle slot. NOTE: Do not tighten safety belt (H). Bottom buckle slot Top buckle slot 4 5 BELT GUIDE BELT GUIDE NOTE: To attach screen to wall plate, spacers may be needed. Refer to wall mount instructions for use of spacers. 6 Tighten safety belt (H) by pulling on loose end of safety belt.
PAGE 5
7 Make sure that attachment brackets (not included) are at desired tilt before installing to wall plate (not included). Measure display hole pattern before securing display to wall plate (not included). Large Mounting Hole Pattern Vertical brackets Outside If display mounting pattern is larger than distance between vertical supports of shelf mount brackets, position attachment brackets on outside with ratchet handles facing outward as shown in Fig 7.1. RATCHET HANDLE ATTACHMENT BRACKETS Fig. 7.1 18.