Installation Owner's manual

ManualsBrandsPeerless-AV ManualsMonitorsDS-VW650

ISSUED: 09-24-10 SHEET #: 125-9146-2 (6-25-13)

Visit the Peerless Web Site at www.peerlessmounts.com

1 of 5

Installation and Assembly:

Wall Mount

Model: DS-VW650

A B C

D E F

H I J

Description Qty. Part #

wall plate 1

145-1199

lock bracket 1

145-1201

C vertical bracket 2 145-1200

M5 x 10 mm socket pin Type F screw 2

520-1164

#14 x 2.5" hex head wood screw 6

5S1-015-C03

F concrete anchor 6 590-0320

4 mm allen wrench 1 560-9646

H nylon shoulder washer 4 590-2233

I M6 x 12 mm phillips screw 4 5201128

J M8 x 15 mm phillips screw 4 520-9257

Parts List

Summary of content (5 pages)

PAGE 1
Installation and Assembly: Wall Mount Model: DS-VW650 A Parts List A B C D E F G H I J D H Description wall plate lock bracket vertical bracket M5 x 10 mm socket pin Type F screw #14 x 2.5" hex head wood screw concrete anchor 4 mm allen wrench nylon shoulder washer M6 x 12 mm phillips screw M8 x 15 mm phillips screw Qty. 1 1 2 2 6 6 1 4 4 4 B C Part # 145-1199 145-1201 145-1200 520-1164 5S1-015-C03 590-0320 560-9646 590-2233 5201128 520-9257 E F I J G 1 of 5 Visit the Peerless Web Site at www.
PAGE 2
Installation to Wall Stud WARNING • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. • Never tighten in excess of 80 in. • lb (9 N.M.). • Make sure that mounting screws are anchored into the center of the stud.
PAGE 3
Installation to Solid Concrete or Cinder Block WARNING • When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. Cinder block must meet ASTM C-90 specifications.
PAGE 4
2 Attach adapter brackets (C) to display using four M6 x 12 mm phillips screw (I) with nylon shoulder washers (H), or using four M8 x 15 mm phillips screws (J). I or J H C DISPLAY Attaching Adapter Brackets to Wall Plate 3 Hook adapter brackets (C) to wall plate (A). Slide adapter brackets (C) to position. Once display is located in desired position, secure with lock bracket (B) using two M5 x 10 mm socket pin Type F screws (D) to lock in place as shown in figure 3.2. DISPLAY B C D A A Figure. 3.
PAGE 5
Optional for Multiple Displays: Installing Spacer Kit (Sold Separately) 4 Slide spacers into tab of mounted wall plate as shown. Keeping spacers flush against wall plate, fasten two #10 x 3/4" wood screws as shown. There must be two spacers placed on the same side as the additional wall plate. Align the tabs of the additional wall plate flush with the spacers. Follow main instruction for proper installation of additional wall plates.