Instruction Manual

2
2020-08-10 #:146-9051-1
Symbols
ENG
WARNING
ENG
Do not overtighten screws.
ENG
#
Skip to step.
ENG
Wear anti-static gloves.
ENG
1
2
ENG
To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
4
+1/2
3
ENG - This product is designed to be installed on plywood walls, solid concrete or cinder block walls. Hardware
is included for plywood installation. This product is designed to be installed on at, unobstructed, vertical walls.
Do not install on curved or angled walls. Before installing make sure the supporting surface will support the
combined load of the equipment and hardware. Screws must be tightly secured. Do not overtighten screws or
damage can occur and product may fail. Never exceed the Maximum Load Capacity. Always use an assistant or
mechanical lifting equipment to safely lift and position equipment. This product is intended for indoor use only.
Use of this product outdoors could lead to product failure or personal injury. Be careful not to pinch ngers when
operating the mount. For support please call customer care at 1-800-865-2112.
WARNING
x3
Screws must get at
least three full turns
and t snug.
ENG