Installation Owner manual

ISSUED: 12-01-08 SHEET #: 120-9065-2 08-18-09

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.

6 of 25

Hand tighten slope nut through 1/4-20 x 1 3/4"

carriage bolt until snug against bottom of desktop

surface. Thread another slope nut upside-down,

about two turns from rst slope nut . Insert a open

box wrench between both slope nuts and tighten.

NOTE: Avoid jamming both slope nuts together,

doing so may make it difcult to remove slope nut

used for tightening rst slope nut. After slope nut is

secure remove bottom slope nut and add plastic cap

as shown in gure 5.2. Repeat with remaining

1/4-20 x 1 3/4" carriage bolt .

RUBBER

FEET

Attach lock-down plate to display base bottom using

screws provided. Refer to lock-down hole pattern for

screw placement. Refer to page ve for rubber pad

placement pattern.

NOTE: Remove existing rubber feet from display base

that interfere with the lock-down plate.

NOTE: Display base stand and mounting

hole locations may appear different than

illustrated.

DISPLAY BASE STAND

LOCKDOWNPLATE

BOTTOMOF

DESKTOP

FIG5.1

TIGHTENING

SLOPENUT

FIG5.2