Installation Owner manual

ISSUED: 12-01-08 SHEET #: 120-9065-2 08-18-09

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.

18of25

FRONT OF TV STAND

1/8"

Slide stand back into front lock-down bracket, then attach back lock-down bracket (B) to desktop using

10-16 x 3/4" penta pin screw at either location 1 or 2 as shown at bottom left. Tighten securely with penta pin

driver .

NOTE: Use nylon cap covers with 10-16 x 3/4" penta pin screws (supplied with FLD-UNV-LG) when using hole 1

of back lockdown bracket as shown at bottom right.

TV STAND

LOCK-DOWN BRACKET

STAND BASE MAY BE

DIFFERENT THAN

ILLUSTRATED

LOCK-DOWN BRACKET

Thread four # 10 x 3/8 phillips screws (D) for option 1 or remove existing rubber pads and screws and replace

them with four #8 x 1/2 phillips screws (E) for option 2 into front holes, leaving 1/8" of exposed thread.

Flip desktop stand right side up and slide into front lock-down bracket so that screws in front holes locks securely

into slot of front lock-down bracket as shown below.

D or E