Installation User Manual

2 of 4

ISSUED: 02-06-07 SHEET #: 054-9125-2 07-30-07

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

Drill two 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach ceiling plate (A) with two #14 x 2.5" (6

mm x 65 mm) wood screws (B) as shown using 3/8" (10 mm) socket wrench.

IMPORTANT: Be sure to drill holes into the joist CENTER!

Installation To Wood Joist Finished Ceilings,

Exposed Wood Joists, or Wood Beam Ceilings

• Installer must verify that the supporting surface will safely support the combined weight of mount and projector.

• Tighten wood screws so that ceiling plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is

highly recommended.

WARNING

WOOD JOIST

CEILING