Owner's Manual
9
You MUST make sure the stem & handlebar is inserted beyond the minimum inseron mark. If you don’t you may damage
the bike or the stem. You may also lose control and fall, which could cause you serious injury. Once you have nished
assembling you should test the stem by holding the front wheel between your leg and trying to turn the handlebars. If
these turn without turning the front wheel you need to line the handlebar back up and re-ghten.
WARNING
3C MUDGUARD INSTALLATION
Your bike may have come equipped with mudguards. The front mudguard will usually come separate in the box and will need ng.
First, remove the nut from the bolt in the top of
the fork using the spanner provided, leave the bolt
in place through the fork. Then remove the two
screws from the feet of the fork using a crosshead
screwdriver.
You can then locate the mudguard in place. First feed
the mudguard through the back of the fork as shown.
Locate the mudguard on the bolt you le in the fork
as and screw the nut on clockwise unl it is nger
ght. You can then screw the mudguard to the feet of
the fork by replacing screws through the mudguard
brackets and into the fork, ghtening them by turning
clockwise with a crosshead screwdriver. Tighten the
nut on the top of the fork turning clockwise using the
spanner provided.
i
ii