Owner's Manual

Handlebar rotaon

If you need to adjust the angle of your handlebar, you can do this by losening the

clamping nut. The handlebar will then rotate freely in the stem. Adjust to desired

angle, and ensuring the bar is sll centred in the stem, ghten the clamping bolt.

To adjust or install stem, you need to loosen the centre bolt enough so that the stem will t / become loose in the steerer tube,

by turning it an-clockwise with allen key provided.

You can then insert or adjust the stem. You can rotate it le to right and you can also adjust the height. It is very important

that you observe the minimum inseron mark and that you insert the stem beyond this. This must not be visible once the

stem is installed.

Once your stem is in place and in line with the forks, ghten it up by turning the centre bolt clockwise (it may be easier to re-

adjust this with the front wheel ed, so the stem is in line with it).

i ii iii

iii

MINIMUM

INSERTION

MARK

Front of bike

Rear of bike

TIGHTEN LOOSEN