Owner's Manual

27
We then need to t the cable to the break lever. Ensure the slots on the cable tension screw are in line with the slot on the
brake lever housing.
Squeeze the brake lever and insert the brake cable into the slot as shown below.
With the brake lever closed, you can now pull the brake cable outer casing and insert the cable through the sloths in the brake
lever housing and the brake cable tension screw.
Once the brake cable outer housing has sloed into the brake cable adjusng screw, turn this screw so that the slots are no
longer aligned and the cable can no longer come out.
iv
v
vi
vii
iv v vi vii
Cable tension
screw
Always test the brakes before riding. Should you need to adjust them, visit the brakes secon of this manual
IF YOU HAVE ANY PROBLEMS OR ARE UNSURE ABOUT ANY OF THESE STEPS, CONSULT A QUALIFIED BICYCLE MECHANIC