Owner's Manual

Seng gears on a front derailleur

Whilst turning the pedals, set the le hand gear shier to

the lowest gear (smallest cog at the front), and the right

hand shier to the highest gear (smallest cog at the back)

You should check that the chain is running freely through

the cage on the front derailleur without catching. If it

catches you can move the cage by slightly adjusng the ‘L’

screw.

Leaving the le hand gear shier where it is, set the right

hand shier to the lowest gear (largest cog) and repeat

step ‘ii’

Change the le hand shier up one gear. If the gear doesn’t

change smoothly onto the next cog, you can adjust the

cable tension screw. For the front derailleur this is found

either on the gear shier (check which one you have in the

following secon), or on certain road bikes it is found on the

downtube of the frame, just above the gear cable guide.

Turn slightly and keep tesng unl you have achieved the

desired result.

Once the gears are changing correctly shi the le hand

shier on the highest gear and check that the chain cannot

clear the cage and come o the cog over the top. If it can,

you can adjust it by slightly turning the ‘H’ screw with a

phillips screwdriver.

iii

LIMITER SCREWS

These are marked ‘H’ & ‘L’,

and are sometimes found

in dierent positions on

the derailleur

CAGE

This guides the

chain between

the cogs

CABLE TENSION SCREW

This may be located on the

shifter. On some road bikes

however it is found on the

frame