Owner's Manual

Line the holes in the basket plate and the frame bracket up and

insert the screws / washers / xing plate as shown. Then from

behind the frame bracket, place the washers on the screws and

screw the nuts on clockwise nger ght.

iii

3G. STABILISERS

Remove the outer nut and washer from each side of the back wheel by turning an-clockwise using the spanner provided

Place the bracket over the thread ensuring the tabs lock in the dropout, followed by the stabiliser, the washer and the nut. Tighten the

nut by turning clockwise unl it is nger ght. Repeat for the other side.

Once both stabilisers are nger ght, ensure they are both around 5mm from the

ground with the bike vercal. This is to ensure that if the bike goes over uneven ground

the rear wheel won’t be lied of the ground causing it to lose tracon.

Tighten both nuts by turning clockwise using the spanner provided

iii

WARNING

Stabilisers are an important

balancing aid for young children.

Bikes equipped with stabilisers

should not be ridden on uneven

ground. Regularly check all

stabiliser ngs, including the

locking tabs to ensure nothing

has come loose. If you are

unsure please contact your local

bike dealer who should be able

to help you.