Owner's Manual
12
If your bike comes with a tradional basket the bracket for this needs be installed before we can secure the wheel in place. You
will need to remove the nuts completely from the front wheel before sing the wheel in the front dropouts.
With the wheel sat in the fork, insert the locking washers on to the axles, securing the pin in place as shown.
Then insert the basket bracket, with the at part facing towards the bike frame as shown.
Finally, screw the nut on clockwise. You should only screw this on nger ght for the me being, we will ghten it once
the basket is installed.
a
b
c
IF YOU HAVE A TRADITIONAL BASKET
THE PIN ON THE
LOCKING WASHER
MUST BE PLACED
IN THE HOLE.
a b c
Should you need to remove your wheel to replace it or to repair it, simply reverse these steps.
Place the pointed side of the locking washer into the hole
in the fork as shown, then ensuring the gap between the
wheel and the fork is equal on both sides, ghten the
nut by turning clockwise using a spanner. Recommended
torques can be found at the back of this catalogue
iii
THE PIN ON THE LOCKING
WASHER MUST BE PLACED
IN THE HOLE.