Quick Assembly Guide
4.- FITTING THE STABILISERS
Remove the outer nut and washer from each side of the back wheel by turning an-clockwise using the spanner provided
Place the bracket over the thread ensuring the tabs lock in the dropout, followed by the stabiliser, the washer and the nut.
Tighten the nut by turning clockwise unl it is finger ght. Repeat for the other side.
Once both stabilisers are finger ght, ensure they are both around 5mm from the ground with the bike vercal. This is to
ensure that if the bike goes over uneven ground the rear wheel won’t be lied of the ground causing it to lose tracon.
Tighten both nuts by turning clockwise using the spanner provided
i
ii
iii
iv
v
TOOLS NEEDED
SPANNER
9
IF YOU ARE EXPERIENCING ANY PROBLEMS PLEASE CALL 0161 813 1745 BEFORE RETURNING BIKE TO STORE