User Guide

14
1. Press System to select system
preferences.
Note: Selected option  ashes.
2. Press ▲/ ▼ to select Heat, Cool,
Auto, Off, or Em (Emergency).
3. Press Done to save changes.
In “Heat” and “Cool” modes, only one
setpoint is displayed for each, and only the
selected mode (e.g.,Heat) is applied. “Auto”
mode switches automatically between Heat
and Cool. Auto mode controls the room’s
temperature to the programmed Heat
and Cool Setpoints. “Off” mode disables
all thermostat outputs; and only the zone
temperature and clock are displayed. If
Emergency (Em) heat is enabled in a Heat
Pump system, Emergency acts as the primary
heat source.
SELECT SYSTEM MODESELECT SYSTEM MODESELECT SYSTEM MODE
Note
: System modes available
depend upon which system type is
selected in Service Menus.
i
PRESS ANY KEY TO BEGIN
Press ▲/ ▼ to scroll through options for system
preferences. The selected option flashes.
Setpoint is displayed on the right side of the screen.