Accessory List

CC-8118-120
F-27382-1 © Copyright 2006 TAC. All Rights Reserved. 33
Accessories
Specifications (Continued)
Control output voltage
Control of TAC System 8000
devices
2 to 15 Vdc paralleling or sequencing five additional TAC System 8000 devices. Factory calibrated
for 7.5 Vdc with sensor at setpoint temperature.
Proportional control of electric
heat
6 to 9 Vdc between each HTG relay outputs.
Power requirements Refer to Model Chart.
Power supplies available
6.2 Vdc, 4 mA
These regulated and filtered power supplies must not be connected to +20 (red) or +6.2 of other
supplies.
20 Vdc, 35 mA
Environment
Ambient temperature limits
Shipping and storage: -40 to 160°F (-40 to 71°C).
Operating: 40 to 140°F (4 to 60°C).
Humidity 5 to 95% RH, non-condensing.
Locations NEMA Type 1.
Connections
Control Coded screw terminals for 14 to 20 AWG.
Power Color coded pigtails.
Case Metal with four 1/2 to 3/4 in. conduit knockouts, two on each end.
Mounting Inside location near the controlled equipment using the four keyhole slots.
Dimensions 10-3/8 H x 7-1/4 W x 3-1/8 D in. (263 x 184 x 79 mm).
Agency Listings UL Listed, CUL.
General Instructions Refer to F-17219.
Model No. Description
AD-8969-201 Offset resistor kit; 5, 10, 15, and 20°F.
AT-8122 Remote setpoint adjuster, dual scale 20 to 120°F (-6 to 49°C).
AT-8155 Remote setpoint adjuster, dual scale 50 to 250°F (10 to 120°C).
AT-8158 Remote setpoint adjuster, dual scale 55 to 85°F (13 to 29°C).
CC-8102 Electronic relays for additional stages for linear sequencers.
TS-8101 Room sensor.
TS-8111 Room sensor with setpoint.
TS-8131 Room button type sensor.
TS-8201 Duct/immersion sensor.
TS-8261 Light fixture sensor.
TS-8405 Averaging sensor, 5 ft. (1.5 m).
TS-8422 Averaging sensor, 22 ft. (6.7 m).
TS-8501 Outdoor sensor.
TS-8601 Selective ratio discharge sensor.
TOOL-201 Calibration kit for TAC System 8000.