Accessory List

Accessories and Tools
340
© Copyright 2006 TAC. All Rights Reserved. F-27382-1
Application
TAC DuraDrive
The AM-705 and AM-706 positioners are used for remotely
controlling or setting minimum position of proportional
actuators. The AM-705 is for surface mounting. The AM-706 is
for flush mounting.
Specifications
• Actuators: MS40-7043, MS4x-7073, MS4x-7153, MS40-717x,
MS41-6083, MS41-6153, MS41- 6343, and MS4D-xxxx-x00.
• Control range is 0 to 100% of the actuator rotation angle.
• Power supply: 24 Vac ± 20%, 50/60 Hz, 24 Vdc ± 10%.
• Control Signal: 0.5 to 10 Vdc, 2 to 10 Vdc (switchable).
• Power output: Up to 10 actuators (1mA max).
• Degree of protection (AM-705 only): NEMA 4 (IP54).
• Connection: Terminals, 14 gauge wire max.
• Humidity: 5 to 95% RH non-condensing.
• Refer to F-26895 for complete applications.
• Half wave device.
AM-705 and AM-706
Positioners
Application
The AM-708 500 ohm resistor converts a 4 to 20 mA signal to a
2 to 10 Vdc signal.
Specifications
• Actuators: MS40-7043, MS41-7073, MS41-7153, MS40-717x,
MS41-6083, MS41-6153, MS41-6343, and MS4D-xxxx-x00.
• Wire leads.
• Refer to F-26895 for complete applications.
AM-708
500 Ohm Resistor
Application
TAC DuraDrive
The AM-709 damper shaft position indicator is used in short
shaft applications to show the shaft position.
Specifications
• Actuators: Mx40-704x.
• Shaft sizes:
- Up to 3/4" diameter round shaft
- Up to 1/2” square for square shaft.
- Secured to actuator with retaining ring.
• Refer to F-26896 for complete applications.
AM-709
Damper Shaft Position
Indicator/Stroke Limiter
AM-706
AM-705