Accessory List

Accessories and Tools
336
© Copyright 2006 TAC. All Rights Reserved. F-27382-1
Application
Tac DuraDrive
The AM-676 universal shaft extension extends the length of
the damper shaft in applications where the damper shaft is too
short to reach the damper actuator.
Specifications
• Length: Approximately 9-1/2 in. (13 mm).
• Damper shaft sizes:
- 3/8 to 11/16 in. (10 to 17 mm) diameter for round shafts.
- 3/8 to 9/16 in. (10 to 14 mm) square for square shafts.
• AM-710 is required for MA40-704x series, MF40-704x series and
MS40-704x series.
• To be used with the following damper actuators:
- Mx40-704x. MF41-6083.
- Mx4x-707x. MS41-6083.
- Mx4x-715x. MF41-6153.
- Mx40-717x. MS41-6153
- MF4x-6043. MF41-6343.
- MS4x-6043. MS41-634x.
-MS50-E2x01.
-MS50-H2x01.
• Refer to F-25098 for complete applications.
AM-676
Universal Shaft Extension
Application
TAC DuraDrive
The AM-686 damper position indicator mounts on the actuator
to indicate actuator position when the V-bolt indicator is not
visible.
Specifications
• Material: Plated steel.
• Mounts on the following actuators:
- Mx4x-707x.
- Mx4x-715x.
• Refer to F-25098 for complete applications.
AM-686
Damper Position Indicator
Application
TAC DuraDrive
The AM-687 universal clamp assembly is used to replace the
standard universal clamp assembly when a larger diameter
damper shaft must be gripped, up to 1.05 in dia or up to 5/8 in
sq. The AM-688 replacement universal clamp is used to clamp
the actuator on shafts up to 3/4 in. dia. or up to 1/2 in. sq.
Available to replace lost standard clamps shipped with
actuator.
Specifications
• Material: Plated steel.
• Mounts on the following actuators:
- Mx40-707x.
- Mx4x-715x.
• Refer to F-25098 for complete applications.
AM-687, AM-688
Universal Clamp Assembly