Accessory List

Accessories and Tools
F-27382-1 © Copyright 2006 TAC. All Rights Reserved. 321
Application
TAC System 8000
This signal selector offers selection of either the highest or
lowest signal from up to six zones. One model can be used for
either high or low signal selections. The selector has the
capability to drive up to 12 TAC System 8000 controlled
devices. It has TAC System 8000 compatible terminology. The
AD-8201 offsets input to output adjustment. Standard trade
mounting.
Specifications
• Input to Output Ratio: Factory calibrated for a 1:1 ratio. Output
adjustable ±4 Vdc with respect to the input signal.
• Outputs: Signal is equal to either the highest or lowest input
signal. Selector pins change the unit from a high to a low signal
selector.
• Power requirements: 20 Vdc, 10mA.
• Mounting: Panel mounted to a track section. AD-8912 enclosure
ordered separately for remote installations.
• Dimensions: 4 H x 7-1/2 W x 2-1/2 D in. (101.6 x 190.5 x 63.5
mm).
• Accessories:
- AD-8912, 12 in. (308.4 mm) enclosure.
- TOOL-201, Calibration kit for TAC System 8000.
• Refer to F-14963 for complete applications.
AD-8201
High/Low Signal Selector
Application
TAC System 8000
This selector provides high voltage, manual, or minimum
selection for controlled devices. The selector has the
capability to drive up to 5 TAC System 8000 controlled
devices. AD-8301 has automatic high signal select in minimum
position operation. Universal mounting capability with
selected hardware. Track mounting with AD-8954.
Specifications
• Operation:
- Manual positioner: Produces a 6 to 9 Vdc swing with the
pointer between minimum and maximum markings when the
knob is pulled out. CCW to CW rotation produces 1 to 15 Vdc.
- Minimum positioner: Produces a 6 to 9 Vdc minimum position
signal by adjusting the pointer between the minimum to
maximum markings when the knob is pushed in. CCW to CW
rotation produces 1 to 15 Vdc minimum output. Output to the
controlled device equals the controller output but is not less
than the minimum established by the positioner.
• Mounting: Surface, but can be mounted on AD-8954 for panel
mounting. AD-8954 can snap into an AD-8953 mounting track.
• Dimensions: Plate is 2-1/16 H x 1-7/8 W in. (52 x 48 mm). Allow
1-1/2 in. (38 mm) depth behind plate for mounting. Requires a
3/8 in. (9.5 mm) diameter mounting hole.
• Accessories:
- AD-8953, Mounting track (requires AD-8954).
- AD-8954, Panel mounting bracket.
• Refer to F-25795 for complete applications.
AD-8301
Position Selector - Manual/Minimum
H
IG
H
/L
O
W
A
D
82
01
MAX