Accessory List

VER-PHx Series
304
© Copyright 2006 TAC. All Rights Reserved. F-27382-1
Pressure Transducer
Model Chart
Specifications
The VER-PHx Series Pressure Transducer is used
for the proportional pressure control and/or
monitoring pressure of steam (steam siphon
required), air, gases, or liquids. Microprocessor
based for improved accuracy and reliability.
Features:
• ± 1% accuracy (including linearity, hysteresis, and
repeatability).
• Micromachined silicon pressure sensor.
• Up to 200% overpressure without zero shift.
• Over 500% burst pressure.
• Up to three field selectable pressure ranges in a single unit.
• Short circuit and reverse polarity protected.
Model No.
a
a
CAUTION: This product contains a half-wave rectifier power supply and must not be powered off transformers used to power other devices utilizing non-
isolated full-wave rectifier power supplies.
Range (psig) Input Supply Output Supply
VER-PHx-07-S 0 to 25 / 0 to 50 / 0 to 100
24 Vac nominal
12 to 30 Vdc
4 to 20 mA,
0 to 5 Vdc or 0 to 10 Vdc
Each field selectable
VER-PHx-08-S 0 to 62.5 / 0 to 125 / 0 to 250
VER-PHx-09-S 0 to 125 / 0 to 250 / 0 to 500
Inputs
Media compatible Liquid/gases compatible to 17-4 PH stainless steel.
Supply voltage ± 15 or 24 Vac nominal. 70 mA 24 Vdc ± 15% 40 mA.
Load impedance capability 600 Ω minimum.
Maximum supply air pressure 200% of the range.
Operating characteristics Accuracy: ± 1% FS (included linerarity, hysteresis, and repeatability).
Long term stability ±0.25%.
Connections 1/4 inch NPT (Male). Unpluggable screw terminal block for use with maximum 12 AWG wire.
Outputs
Electrical
Signal 3-wire transmitter, 0 to 5 Vdc or 0 to 10 Vdc, 4 to 20 mA,.
DC power supply rectifier type Half-wave. (Refer to previous Caution). EN206, F-26363.
Environment
Ambient temperature limits
Shipping and handling: -4 to 185°F (-20 to 85°C).
Operating: -4 to 185°F (-20 to 85°C). Temperature compensated 32 to 122°F (0 to 50°C).
Humidity 10 to 90%, non-condensing.
Location NEMA Type 1.
Dimensions 5 H x 2-1/2 W x 2-1/4 D in. (127 x 64 x 58 mm).
VER-P
H
Series