Accessory List

TP-8101, TP-8102, TP-8121, TP-8124
272
© Copyright 2006 TAC. All Rights Reserved. F-27382-1
Typical Applications
Figure 4 TP-810x Terminals and Typical Wiring.
Figure 5 TP-8124 Typical Wiring with One MP-52xx Actuator.
1K Ω
1 2
3
8
1
5
BlueDEC
Yellow
Red
COM
OP1
+6.2
3
3
+20 (Red)
IV1 (Yellow)
COM (Blue)
To Controlled
Device
TP-810x
Optional
Remote
Sensor
Except
TS-8601
7
4
4
4
4
8
5
4
4
+20 (Red)
IV1 (Yellow)
COM (Blue)
To Controlled
Device
TP-810x lower right corner.
TP-810x
Optional Remote
Setpoint
AT-8158
7
6
2
4
INC
1
TS-8601
Selective Ratio
Discharge
Sensor
1 Clip out internal sensor if remote sensor
is used.
2 4 to 5 = Direct Acting.
3 4 to 3 = Optional Reverse Acting.
4 For reverse acting only add jumper 1 to
6, blue to 7, and cut jumpers.
6 20
Aux.
Resistor
1 Tape off if red lead.
2 If MP-52xx Actuator is not used, for best performance use regulated and filtered power supply if one is present.
3 The MP-52xx Series also may be used as the cooling device.
1
1
1
TP-8124
(Red) +20
(Blue) COM
(Blue) COM
(Yellow) IV1
(Yellow) IV1
(Blue) COM
(Yellow) IV-
OP2
+20
OP1
COM
Controlled device to max. of
5 additional devices with
filtered regulated or
unregulated power supplies.
Controlled device to max. of
5 additional devices with
filtered regulated or
unregulated power supplies.
(Blue) COM
(Yellow) IV-
MP-52xx Series or
controlled devices with
filtered regulated or
unregulated power
supply (heating).
Controlled device with
filtered regulated or
unregulated power
supply (cooling).