Accessory List

MS40-717x Series
F-27382-1 © Copyright 2006 TAC. All Rights Reserved. 173
Specifications
Accessories
Inputs
Control signal Proportional, 2 to 10 Vdc or 4 to 20 mAdc with integral
500 ohm resistor.
Power Refer to Model Chart.
Connections 2 ft. (0.6 m) appliance cables, 1/2 in. conduit connector. For M20 metric conduit, use AM-756 adaptor.
Outputs
Motor Type Brushless DC.
Mechanical
Direction of rotation: CW or CCW rotation is available through reverse mounting.
Dual shaft clamp: Direct coupled using a through hole output hub.
Position indicator: Pointer and scale are provided for position indication (0° is the normal, or spring
return position).
Stroke: 93° ± 1°
Environment
Ambient Temperature limits
Shipping and storage: -40 to 160°F (-40 to 71°C).
Operating: -25 to 140°F (-32 to 60°C).
Humidity 5 to 95% RH, non-condensing.
Locations NEMA 1, NEMA 4 (IEC IP56) with customer supplied water tight connector.
Dimensions 10-27/32 H x 4 W x 4 D in. (275 x 102 x 102 mm).
Agency Listings
UL
UL-873, Underwriters Laboratories Listed (File #E9429 Category: Temperature-Indicating and
Regulating Equipment).
European Community EMC Directive (89/336/EEC). Low Voltage Directive (72/23/EEC).
CSA Canadian Standards C22.2 No. 4-93.
Australia
This product meets requirements to bear the C-Tick mark according to the terms specified by the
Communications Authority under the Radio Communications Act 1992.
General Instructions Refer to F-26748 and F-27384.
Model No. Description
AM-674 Weather shield.
AM-676 Universal shaft extension, approximately 9-1/2 in. long (242 mm) for use on 3/8 to 11/16 in. (10 to 17 mm)
round shafts, 3/8 to 9/16 in. square shafts. AM-753 clamps required).
AM-703 Span adjustment.
AM-704 Modulating interface.
AM-705 Positioner.
AM-706 Positioner.
AM-707 Digital indication.
AM-751 Standard anti-rotation bracket 9 in. long x 13/16 in. wide (229 x 21 mm), included with actuator.
AM-752 Optional anti-rotation bracket 4 in. long x 1-11/16 in. wide (102 x 43 mm), for narrow spaces.
AM-753 Damper shaft mounting clamps for 5/8 in. square shaft, 3/4 in. and 1 in. round shafts (two per package).
AM-754 Standard universal mounting clamps for 3/8 to 1/2 in. (10 to 13 mm) round and square shafts, two included
with actuator.
AV-602 Vx-7xxx 1/2 to 2 in. valve linkage.
AV-607 Vx-9xxx 2-1/2 to 4 in. valve linkage.
M-756 Metric conduit adaptor M20 x 1.5 to 1/2 in. NPT (two per package).