Accessory List

MPR-5713
162
© Copyright 2006 TAC. All Rights Reserved. F-27382-1
Proportional Actuators
Model Chart
Specifications
The MPR-5713 actuator provides electronic proportional
control of dampers and valves which require a return to the
normal position upon power interruption. The actuator is
compatible with 135 ohm slidewire controllers (Series 90).
Features:
•Spring return.
• Available in damper models or base models that require damper or
valve linkage.
• Die cast lower housing with 1/2 in. conduit opening and painted steel
upper housing.
• Hydraulic actuator with oil-immersed motor, transducer, and pump.
• Proportional actuators controlled by a controller with a 135 ohm
slidewire output.
Model No.
Actuator Power Input
Timing in Seconds
at 72
°F (22°C)
Required Linkages
(Applications)
Input
Signal
AC Voltage
(±10%)
50/60 Hz No Load Stroke Retract on
Power
Loss
Valve
Damper
a
a
The MPR-5713 actuator basic model may be equipped for damper applications with the installation of an AM-601 linkage.
Watts Amps Extend Retract
MPR-5713 24 10 18 60 30 15
AV-7600-1 or
AV-600
AV-601
b
b
May be required for steam and hot water. Refer to “Valve” section in this catalog.
AM-601
Compatible
with 135
Ω
Slidewire
(Series (90)
Actuator inputs
Control circuit MPR-5713: Three-wire 135
Ω slidewire.
Power input Refer to Model Chart.
Connections Color-coded 4 ft. (1.2 m) leads.
Actuator outputs
Electrical
Position signals: Internal feedback circuitry provides positive positioning of the damper in relation to
the controller signal.
Mechanical
Stroke Valve: Approximately 9/16 in. (14 mm) from fully retracted to fully extended.
Output torque rating: The proportional output torque rating of 15 lb-in. (1.7 N-m) is available
throughout the entire stroke and is based on the lowest force available under normal operation, the
spring return stroke, or at a minimum (-10%) supply voltage.
Environment
Ambient temperature limits Shipping and storage: -40 to 140°F (-40 to 60°C).
Humidity 5 to 95% RH, non-condensing.
Location NEMA Type1.
Dimensions 6-3/4 H x 3-1/4 dia in. (171 x 83 mm).
Agency Listings
UL 873 Underwriters Laboratories File E9429 Category Temperature-Indicating and Regulating Equipment.
CUL Certified for use in Canada by Underwriters Laboratories. Canadian Standard C22.2 No. 24-93.
European Community EMN DIrective (89/336/EEC). Low Voltage Directive (72/23/EEC).
General Instructions Refer to F-23576.
MPR
-
5713
MPR-5713