Accessory List

MP-52xx Series
F-27382-1 © Copyright 2006 TAC. All Rights Reserved. 145
Electronic Hydraulic Actuator
Model Chart
These actuators provide electronic proportional
control of dampers, valves, or program switches
requiring the return to normal position upon
power interruption
.
Features:
• Compatibility with 2 to 15 Vdc TAC System 8000 input signals.
• Proportional control by variable Vdc input signal.
• Spring return.
• Fixed 3 Vdc operating span.
• Non-adjustable start point and non-positive positioning.
Typically, one actuator is controlled from one Vdc output signal.
• 10,000 Ω or greater input impedance.
• 24, 120, and, 240 Vac models.
• Damper models with linkage or base models requiring separate
damper or valve linkage available.
• Die cast lower housing with 1/2 in. (12.7 mm) conduit opening
and painted steel upper housing.
• Hydraulic actuator with oil-immersed motor, transducer, and
pump.
Damper Actuators.
Model No.
Actuator Power Input
Timing in Seconds
at 72°F (22°C)
Torque Rating
lb-in. (N-m)
Voltage
(±10%)
50/60 Hz No Load Stroke
Retract on Power
Loss
Watts VA To Extend To Retract
MP-5230 120
10 18 60 40 15 1.86 (0.21)
MP-5233 24
Valve Actuators. Also for Damper Actuators with Field Assembled Damper Linkages.
Model No.
Actuator Power Input
10 Amps
a
Aux Switch
a
Common of switch in series with AC power supply to the motor. Therefore, the switch must be wired to control the same voltage as the actuator itself.
Timing in Seconds
@ 72°F (22°C)
Required Linkage
Voltage
(±10%)
50/60 Hz No Load Stroke
Retract on
Power Loss
Damper Valve
Watts VA To Extend To Retract
MP-5210
120
10 18
No
60 40 15 AM-601
AV-600 or
AV-7600-1
AV-601
b
b
May be required for steam, hot or chilled water. Refer to Maximum Allowable Ambient Air Temperature for Valve Actuators.
MP-5210-500 Yes
MP-5211
240
No
MP-5211-500 Yes
MP-5213
24
No
MP-5213-500 Yes
P
-
52
xx
r
ies
MP-521X
V
alve Actuator
MP-523X
Damper Actuator