Accessory List

MFC-8000
132
© Copyright 2006 TAC. All Rights Reserved. F-27382-1
Figure 3 MFC-8000 Control Module Switch and Adjustment Locations Showing Wiring Designations,
Typical Factory Switch, and Shorting Block Settings.
Note: Extend point is the voltage required to drive an actuator to fully extended position. This is set at SW1. SW2 switches 1 thru 8 determine
span. SW2 switches set hysteresis (9 and 10).
Switch Blocks with Dip Switches
Extend Point
Span
(1-8)
Top
Direct/Reverse Action
Shorting Blocks
Not Used
1
2
3
(+) Positive mAdc Input
(-) mAdc Input (Common)
Mounting Pin
Brackets
Wiring
Terminal
Hysteresis (9, 10)
SW1
SW2