Operation Manual
This jack provides a direct connection to the input of the power-amp section and can also be used in
conjunction with the PREAMP OUTPUT jack as an auxiliary loop for higher-level effects or a master volume
pedal.
This jack provides a low-level return for outboard effects outputs and can also be used as a low-level
power-amp input.
This control sets the intensity of the front-panel backlighting.
This jack may be used to send a straight, buffered signal to an electronic tuner, or it can be used as a
signal pass-through to send a signal to another amplier for bi-amping. This jack is always active when
the power is ON.
When this switch is in the OUT position, the DI is driven from the rst tube stage before the EQ. When the
switch is in the IN position, the DI is driven from the output of the preamp after the graphic EQ.
This balanced XLR output provides a direct connection to a mixer or recording device.
Sets the LINE OUT ground to be either common with the amplier (out) or lifted from the amplier (in) for
the purpose of ground loop and hum elimination.
This control sets the level of the LINE OUT jack that is sent to the respective mixer or recording device.
This jack provides a low-level send for outboard effects inputs and also be used as a low-level send to an
external power amp.
This jack provides a direct connection from the output of the preamp section, so that it can be "slaved"
into an additional power amp and used as a "send" to compete a loop as described above in the POWER
AMP INPUT description.
6
7
8
9
10
11
12
13
14
15
9
8
7
6
5
4
3
10
11
12
13
14
15