User Manual

Back Panel

POWER AMP 2 SPEAKER OUTPUTS (MAIN MIX or MONITOR MIX)

Dual two-conductor ¼” – Speakon combination jacks that can be connected to your speakers. Each amplier has a minimum load imped-

ance of 4 ohms. is means you can connect either one 4-ohm, one 8-ohm or two 8-ohm speakers to each amplier. Do not operate below

rated minimum impedance. For maximum power transfer and to prevent damage to your amplier, be sure to use speaker cables and not

instrument cables to connect to the speakers. We recommend the use of 18-guage or larger speaker wire. e signal going to Power Amp 2 is

determined by the position of the Power Amp 2 Assign switch (20). In the “MAIN” position, the main mix is fed to power amp 1 and power

amp 2. In the “MON” position, the main mix is fed to power amp 1 and the monitor mix is fed to power amp 2.

Footswitch (TRS) Eects Defeat/Mic Mute (Global)

is 1/4" (TRS) jack accepts a momentary 1/4" TRS dual button footswitch (Peavey part # 03014070) designed to defeat the eects (tip to

sleeve) and activate the MIC MUTE switch (39, ring to sleeve). e status of either function will be displayed by the lighting of the switch on

the front panel. If the eects are muted, either by the footswitch or the front panel switch (33), the EFX MUTE switch will glow red. If the

Mics are muted, either by the footswitch or the front panel switch (39), the MIC MUTE switch will glow red.

A single button footswitch (Peavey part # 03050680) can be used, but it will only work on the "Eects Defeat". In this case, the "Mic Mute"

status can only be toggled by the front panel switch (39).