PEARL DRUM PEDAL P-3000 Instruction Manual Congratulations on your purchase! To get optimum performance of your "P-3000D" Drum Pedal, please read this Instruction Manual before playing. ADVANCED Control Gore Beater Direct Link Beater Stopper —— Beater Holder Link Key Bolt — Koy Bolt (for Boater roan Position Adjustment) Key Bolt Key for Foot board Angle Traction Plate —. {fof Beater Toke enlistment) .
Control Core Beater Setting Insert the Control Core Beater Into the Beater Holder Link unt] ft stops against the Beater Setting Stopper, and tighten the key bolt with the provided Ult] Function Drum Key Make sure that the Beater Setting Stopper is flush against the Ester Holder Link with the flat face square against the Notch (Fig. 1-B). Is centered In the Window as shown (Rg. 2). Tha Intel set: ting ls where this Index Mark and the line on the shay In signed.
Direct Link Adjustment The Direct Link can be adjusted to provide a Heavier or a Lighter feel. Duo-Deck Foot board ‘The P-3000D features the Duo-Deck Goatherd, the world's first convertible Short / Long foot board. *H* Position (Heavier Foal) ‘The Direct Link ks set at the factory In the Heavier Feel "H* Post ion To change to a Lighter feel, remove the Key Bok with the Ult-Function Drum Key as shown, Move the Direct Link to the forward set of holes and re-attach the Key Bolt.
Reattach the Hinge to the Foot board in the position shown With two 3-Piece Screws using the provided Ult-Function drum key or Allen trenchermen} {Fig.11). Fig. 11 Place the Heel Plate between the Foot board and the Hinge {Fig.12) and attach the Heel Plate with the remaining two plectra screws using the Mull-Function Drum Key or Allen trenchermen. Attach the Hinge to the Bottom Plate with the Flat Head Screw using the Multi-Function Drum Key or Allen wrench) (Fig.
Reattach the Hinge to the Foot board in the position shown with two 3-Piece Screws using the provided Multi-Function rum ley or Allen wrench} (Fig. 11}. Fig. 11 Place the Heel Plate between the Footwear and the Hinge (Fig.12} and attach the Heel Plate with the remaining two 3 Piece screws using the Mute-Function Drum Key or Allen trenchermen. Attach the Hinge to the Bottom Plate with the Flat Head Screw using the Multi-Function Drum Key or Allen wrench} (Fig.12).
Traction Plate / Traction Dots The Traction Plate adjusts to a variety of graveside configurations, To change the potion of the Traction Dots, use the Multi-Function Drum Key or Allen wrench) to remove the 3-Piece Screw beneath the foot board and remove the Traction Plate (Fight. Rearrange the Traction Dots to your preference and replace the Traction Plate. The Aluminum Traction Dots can ba replaced with optional NP283N/7 Rubber Dots for more traction.
