User Manual

Base

Upper Tube

Pull Rod

Rubber Tip

Footboard

Radius Rod

Wing Bolt

Spring Tension Adjustment Dial

Hi-Hat Clutch

Hi-Hat Cup

Wing Nut

StopLock

Congratulations on your purchase!

To get optimum performance from your H-830 / H-930 Hi-Hat Stand,

please read this Instruction Manual before playing.

H-830/H-930

PEARL HI-HAT STAND

Instruction Manual

(Illust：H-930)

Die-Cast Joint

PAGE 1
PEARL HI-HAT STAND H-830/H-930 Instruction Manual Congratulations on your purchase! To get optimum performance from your H-830 / H-930 Hi-Hat Stand, please read this Instruction Manual before playing.
PAGE 2
Footboard Attachment / Base Assembly Upper Section Assembly Lay the Base Assembly horizontally on the floor. Squeeze the Radius Rods together and insert the ends into the Holes in the Support Casting as shown (Fig.1). Loosen the Wing Bolt and open the legs. Stand the Base Assembly vertically and adjust the legs to form a stable tripod. The Support Casting should be flat on the floor. Tighten the Wing Bolt to secure. Remove the Pull Rod from the Upper Tube.
PAGE 3
Attaching the Hi-Hat Cymbals CAUTION Please have your Hi-Hat Cymbals ready. First, place the Bottom Cymbal on the Hi-Hat Cup as shown (Fig.5). Remove the Bottom Lock Nut and one of the Felt Washers from the Hi-Hat Clutch. Insert the Hi-Hat Clutch into the Top Cymbal and replace the Felt Washer and the Bottom Lock Nut as shown (Fig.5-A). Insert the Pull Rod through the Hi-Hat Clutch as shown (Fig. 5). The distance between the Top and Bottom Cymbals can be adjusted by stepping on the Footboard.