User manual

Fig.19
The inscription "HH" on the Rubber
Foot stands for "Hi-Hat" and is the
factory set position for the H-2050. Do
not change this setting for best
performance (Fig.18).
Fig.18
Base Tube
CAUTION
While docking, support the
Pedal Frame to avoid injury.
CAUTION
The Spikes are sharp and can cause serious personal or property
injury. To prevent mishaps, use extreme care when handling the stand
especially when the Spike Tips are exposed. A rug or carpet should
be used to protect floor surfaces whenever the Spikes are used.
http://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in China
-1601-
Maintenance
The Base Tube (shown to the
right) is secured to the
Support Casting with Allen
screws. In the event the Base
Tube becomes loose, tighten
the Allen screws with the
provided hexagonal wrench
to restore stability.
CAUTION
Periodically check all Allen Screws for tightness and
tighten them with the provided hexagonal wrench as
needed.
Periodically lightly lube external moving parts such as
the Chain, Wing Nuts, Wing Bolts, Key Bolts, and
Footboard Hinge to achieve optimum performance
from your stand.
To maximize traction of the rubber mat beneath the
heel plate, keep it clean and dust free using a damp
cotton towel.
Tighten the Key Bolt to
secure the Pedal Frame to
the Docking Station.
Make sure the Tab is
properly seated as shown
before tightening the Key
Bolt to prevent damage to
the Tab and/or Key Bolt
(Fig.20).
Dismantling the Pedal Frame
Loosen the two Key Bolts on both side of the bottom of the
Support Casting, open the Clamp and remove the Pedal
Frame from the
Support Casting.
Loosen the Key
Bolt on the Docking
Station and
disengage the Tab.
Locate the square
slot on the Strut
End and the square
prong on the
Docking Station.
Make sure that they
are aligned and
insert the Strut End
into the Docking
Station. Keep the
Docking Station
and the Pedal
Frame parallel to
each other (Fig.19).
Fig.20
Allen Screw
Tab
Key Bolt
Strut End
Docking Station