Operation Manual
29
ENGLISH
•
Refer all servicing to authorised service 
agent. Do not attempt to repair the 
product yourself. Servicing is required 
when the product has been damaged 
in any way, such as the supply cord or 
plug are damaged, liquid has been spilled, 
objects have fallen into the product, the 
enclosure is damaged, the product 
has been exposed to rain or moisture, 
does not operate normally, or has been 
dropped.
•
Before connecting the product to a socket 
outlet, make sure the voltage indicated 
on the product corresponds to your local 
mains.
•
If the supply cord is damaged, it must 
be replaced by the manufacturer or its 
service agent or similarly qualified person 
in order to avoid hazard.
•
Regularly check if the supply cord, product 
or extension cable is defective. If found 
defective, do not put the product into 
operation. Immediately pull the plug.
•
Place the supply cord and, if necessary, 
an appropriate extension cable in such 
away that pulling or tripping over it is 
impossible. Do not allow the supply cord 
to hang down within easy reach.
•
Do not jam, bend or pull the supply cord 
over sharp edges.
• Only use the provided adaptor.
•
The adaptor power plug is used as 
the disconnect device; the disconnect 
device shall remain readily operable. To 
completely disconnect the power input, 
disconnect the adaptor power plug.
•
The product may not function properly or 
not react to the operation of any control 
due to electrostatic discharge. Switch o 
and disconnect the appliance; reconnect 
after a few seconds.
•
Protect the supply cord from being walked 
on or pinched particularly at the plug, 
convenience receptacles and the point 
where it exits from the product.
•
Never pull the adaptor power plug by the 
supply cord or with wet hands.
•
Disconnect the adaptor power plug in 
case of faults during use, during lightening 
storms, before cleaning and when not 
using the product for a longer period 
of time.
•
Danger! Before cleaning, switch the 
product o and disconnect the adaptor 
power plug from the socket.
• When the product has reached the end 
of its service life, make it defective by 
disconnecting the adaptor power plug 
from the socket and cutting the cord 
in two.
•
Caution! There is danger of explosion 
from improper replacement of the 
batteries. Replace batteries only with 
the same or equivalent type of battery.
•
Always change the entire battery pack. Do 
not mix old and new batteries, or batteries 
with dierent charge state.
•
Make sure the batteries are correctly 
inserted. Observe the polarity (+) plus / (-) 
negative on the battery and the housing. 
Improperly inserted batteries can lead to 
leakage or, in extreme cases, a fire or an 
explosion.
•
Never expose batteries to excessive heat 
(e.g. bright sun, fire), and never throw 
them into fire. The batteries could explode.
•
The connections must not be short-
circuited.
•
Remove used batteries. Remove the 
batteries if you know that the device will 
not be used for a longer period of time. 
Otherwise, the batteries could leak and 
cause damage.
•
Keep batteries out of reach of small 
children. If batteries have been swallowed, 
seek immediate medical attention.
•
Non-rechargeable batteries must not be 
recharged.
•
Remove the batteries from the product 
before disposal.
IM_PDP270_150518_V03_HR.indb 29 18/5/15 11:35 AM










