Use and Care Manual

3
IMPORTANT SAFETY INSTRUCTIONS
PUMP
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
CAUTIONS:
The pump has been evaluated for use with water only.
Risk of electric shock.
Do not remove cord and strain relief. Do not connect conduit to pump.
Do not use the pump in water exceeding 86ºF / 30ºC.
Do not use the pump in flammable liquids.
Do not use the pump for industrial purposes.
Do not use the pump in vehicles or on board ships or aircraft or swimming pools.
Do not use the pump in location where spe
cial conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapor or
gas).
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
Do not lift the pump by its power cord.
Keep the plug dry. Do not expose the plug to water or steam.
Before connecting to the power source, make sure that the pump is assembled and completely submerged in water.
Al
ways disconnect the pump from the power source before performing any maintenance on the pump, lights (if equipped), or fountain.
Do not exceed the voltage shown on the pump.
Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be fully submerged during
operation. Do not add water while operating the product. Always disconnect the pump from the power source b
efore adding water.
WARNINGS:
1. Risk of electric shock. This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric
shock, be certain that it is connected only to a properly grounded, grounding-type receptacle.
2. To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 ft / 1.52 m in any dimension.
3. If equipped with a 3-prong, grounded type plug, do not remove
the grounding pin from the plug on the power cord.
CARE AND MAINTENANCE