Use and Care Manual

PARTS
TOOLS REQUIRED FOR ASSEMBLY
ASSEMBLY INSTRUCTION
1x
• No tools required
Pump/JR250
Main Body
A 1xB C
2
NOTE: The diagrams shown are for illustrative purposes only and are not to scale
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the main body on a flat, level surface. From the opening at the back of the fountain, insert the water supply tube into the pump outlet on
the top of the pump and connect the LED lights with the light cable separately. Then pleas
e place the pump upright into the basin(Fig. 1& Fig.2)
4. Add clean water into the basin. The water level should be approximately 1 in. / 25 mm lower than the top edge of the opening at the back of the
basin. After that, connect the pump to a GFCI outlet and the product will begin to function as intended. (Fig. 3)
5. If the pump runs with low or high water circulation Check and adjust the regulator dial or slide on the front of the pump. Adjust the dial/slide
towards (+) to increase water flow or towards (-) to decrease water flow. (Fig. 4)
6. The LED lights were pre-assembled, but they are replaceable. When replace them ,please refer to Fig.1.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain.
It is highly recommended that this fountain be placed in an area
where it cannot be damaged that might cause damaged with the fountain .
8. Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
9. Check the area around your fountain on a regular basis to ensure that there is no leakage.