Use and Care Manual

ASSEMBLY INSTRUCTIONS
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Position the part A over the part B. Connect the light power cable which is located under the part A and insert the pump outlet that is on the top of
the pump into the water tube which is located under the part A. Place the pump upright into the fountain body and lead the pump power cord
through out the gas beside the fountain. Place the part A into the part B. Place the stone onto the part A. (Fig.1)
4. Add clean water into the Part B. The water level should be approximately 1 in. / 25 mm lower than the edge of the basin. Connect the pump to a
GFCI outlet and the product will begin to function as intended. (Fig. 1)
5. If the pump runs with low or high water circulation Check and adjust the regulator dial or slide on the front of the pump. Adjust the dial/slide
towards (+) to increase water flow or towards (-) to decrease water flow. (Fig. 2)
6. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after the initial setup of your fountain.
It is highly recommended that this fountain be placed in an area where it cannot be damaged that might cause damaged with the fountain .
7. Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
8. Check the area around your fountain on a regular basis to ensure that there is no leakage.
IMPORTANT SAFETY INSTRUCTIONS
PUMP
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
CAUTIONS:
The pump has been evaluated for use with water only.
Risk of electric shock.
Do not remove cord and strain relief. Do not connect conduit to pump.
Do not use the pump in water exceeding 86ºF / 30ºC.
Do not use the pump in flammable liquids.
Do not use the pump for industrial purposes.
Do not use the pump in vehicles or on board ships or aircraft or swimming pools.
Do not use the pump in location where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapor or
gas).
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
Do not lift the pump by its power cord.
Keep the plug dry. Do not expose the plug to water or steam.
Before connecting to the power source, make sure that the pump is assembled and completely submerged in water.
Always disconnect the pump from the power source before performing any maintenance on the pump, lights (if equipped), or fountain.
Do not exceed the voltage shown on the pump.
Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be fully submerged during
operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.