Use and Care Manual

To ensure proper ignition make sure the igniter pin is properly

positioned and connected.

- The igniter pin should be pointed straight to the thermocouple.

- The thermocouple should be positioned 5mm away from the burner tube.

Make sure that the pilot housing is unobstructed.

Clear any debris on top of the pilot housing and make sure there is no debris between the

igniter pin, thermocouple and the burner tube.

Helpful Tips

If the burner will not light or stay lit,

please perform the following checks.

Turn the control knob to oﬀ and close the LP Gas tank valve. Disconnect the regulator. Turn

the Control Knob to “HIGH”. Wait a minimum of 5 minutes. Turn burner control knob back to

“OFF”. Reconnect the regulator and perform a leak check at tank connection. Turn the LP Gas

tank valve on slowly, wait 30 seconds and then light the outdoor ﬁre table.

It is possible that the Excess Flow Safety Device has been tripped.

Make sure the

wires are fully

inserted into

the ignitor box.

If wires are too

close, or tangled,

they could short.

Make sure they

are spaced apart

from each other.