User Manual

5. Date and Time
This energy cost meter has a built-in system clock, which
is required to switch the day and night tariff. Furthermore,
the device stores the maximum consumption value with
time for better evaluation of the consumption behavior.
• Connect the unit to a wall outlet. The unit
automatically turns on and the voltage measurement
is displayed.
• Press the SET button and starts the day flashing.
• Press the ▲ key to the current day is displayed.
• After further pressing the SET button flashes the
hours of time.
• Press the ▲ key until the correct hour is displayed.
• After further pressing the SET button, minutes flash
on the display of time.
• Press the ▲ key to the current minute is displayed.
• After further pressing the SET button, the time has
been saved.
Press the ▲ button within measurement range menus to
switch between the 24h and the 12h display.
-32-