User Manual

4.Front Panel Operation

(3) Press the ▼ key to select Stop Point submenu. Use the numeric keys to input (1 to

100), press the key to confirm.

(4) Press the ▼ key to select Start submenu. Press the

＜

＞

key to select the

channel (CH1, CH2 or ALL), press the key to enter the data processing interface

and output the selected channel.

4.4.3 Data process

You can set the programmable parameters of CH1 and CH2, including voltage, current and

output time. This function allows up to 100 parameter groups of each channel.

Press the Program key, turn the knob to select [Data process].

Edit:

(1) The Edit sub menu is selected. The operation instruction shows on the screen. Press

the key to enter the data processing interface.

(2) In the data processing interface, Press the

＜

＞

key to move the cursor left and

right. Press the ▲ / ▼ key to move the cursor up and down. Turn the knob to move

the cursor between CH1 and CH2. Use the After selecting the parameter, use the

numeric keys to enter a desired value, press the key to confirm.

Figure 4-1 Data processing Interface

(3) Press

←

to back to sub menu selection.

Graph process is used to configure the graphical display in the Data processing

interface.

(1) Press the ▼ key to select Graph process submenu. Press the key to enter the

editing interface.

(2) In the Graph processing interface, Press the

＜

＞

key to move the cursor left

and right. Press the ▲ / ▼ key to move the cursor up and down. Press the key

to check or uncheck the item. If the item is checked, the corresponding line will be