Datasheet

Übertemperaturschutz
Wenn die innere Temperatur des Gerätes einen voreingestellten Wert
überschreitet, werden die Ausgangspannung und der Ausgangsstrom
automatisch heruntergeregelt und abgeschaltet um Schäden am
Schaltnetzteil zu verhindern. Fällt die Innentemperatur wieder unter
65°C nimmt das Gerät seinen Betrieb automatisch, mit den vorher
eingestellten Werten, wieder auf.
-9-
This manual contains important safety and operation instructions for
correct use of the power supply. Read through the manual and pay
special attention to the markings and labels of this unit and equipment
to be connected.
Pay special attention to these two types of notices used in this
manual.
WARNING:
Failure to observe this warning may cause injury to persons and
damage to power supply or connected equipment.
CAUTION:
Failure to observe this warning may result in damage to
equipment and Improper functioning of the power supply.
WARNING:
1. Do not use this power supply near water.
2. Do not operate or touch this power supply with wet hands.
3. Do not open the casing of the power supply when it is
connected to ac mains.
4. The max. output voltage of model PeakTech
®
6095 is 20VDC,
( PeakTech
®
6135 - 36 VDC), avoid touch the metal contact part
of the output terminals.
CAUTION:
1. Use a grounded 3 pin AC source.
2. This unit is for indoor use only.
3. Do not operate or place this unit in a humid, dusty, in direct
sunlight location or near any heat source.
4. Before plugging into local AC mains, check with the rating label at
the back of the unit.
5. Do not block any ventilation openings of the unit.
6. This unit must be used within the specified rating, regular
excessive continuous loading may cause damage to the power
supply.
7. The gauge size of input power cable must be at least 0.75mm2
and the total length of power cable must not exceed 3m.
-14-