Datasheet

4.)
Power ON
Rotary switch below the monitor.
Switch upward to turn the unit on.
Next rotate upward to turn on the
lighting LEDs placed on the
camera. Turn knob up and down
to dim the LEDs or completely
turn down to turn the power off
again.
5.)
Camera
Connection
Plug the flexible camera with the
guidance in the holder provided.
Turn the nut on the thread of the
camera to fix the attachment. To
release the camera, turn the nut
in the opposite direction and pull
the camera back from the
connector.
6.)
Flashlight
Press the trigger to activate the
flashlight. This additional lighting
is switched independently from
the camera lighting, which is
regulated over the dimmer (item
4: Power ON). To switch off the
flashlight, press the trigger again.
7.)
Battery
Carefully slide the cap forward
until it jumps to the top of the
guide rail. Remove dead
batteries and insert new batteries
into the battery compartment.
Pay attention to the correct
polarity as shown in the
illustration
-19-