User Manual

P/V/F
7.7. Saving Samples
The Meter saves various samples in its three major modes. To save a sample, do the following:
1. When taking a sample, press to store the sample. The Meter can save up to 99 samples
in each of its three modes.
2. If the memory is full (99 samples have been stored), more samples cannot be stored. If the
user attempts to store another sample, the Meter shows "FU" and does not save new readings.
7.8. Recall and Clearing Sample Data
The Meter stores data that sometime will need to be recall and periodically to be cleared. Individual
samples or the entire data memory can be cleared. When the memory is full (99 samples), it shows
”FU” (Full) on the display when is pressed and the Meter emits short beeps and will not save
any value unless some samples are cleared.
To recall sample data, do the following:
1. Press to recall samples for that mode.
2. Press (RECALL) and hold the button for 2 seconds
to recall samples. The last measurement saved appears first.
Use and to locate the desired sample.
3. Once the samples are taken, press to view the
average of all the samples.
4. Press and hold the button for 2 seconds to exit
recall mode.
-36-