User Manual

-47-
Emissivity Set the emissivity factor value manually
from 0.01 up to 1.00 depending on the
measured surface character
Alarm High Set the high- temperature value for setting
off an acoustic and optical Alarm
Alarm Tief Set the low- temperature value for setting
off an acoustic and optical Alarm
Laser Switch ON- or OFF the dual target laser
Auto mode Set if the trigger must be pressed for
measurement or if the device makes
automatic measurement
Max/Min Enable/Disable the display of the
maximum(MAX) or minimum (MIN)
measurement values
Average/Dif. Enable/Disable the display of the average
value(AVG) or the differential
measurement value (DIF) from the
minimum and maximum measurement
values
Ambient Temp.
%RH
Enable/Disable the display of the ambient
air temperature value (AT) and the relative
humidity (RH) in %
Dewpoint/Wetblub Enable/Disable the display of the dewpoint
temperature (DP) or the wetbulb
temperature (WB)
Type-K Enable/Disable the display of the Type-K
temperature probe