Datasheet

1. Introduction
This product complies with the requirements of the following European Community Directives:
2004/108/EC (Electromagnetic Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-Marking). Overvoltage category CAT III 1000V / CAT IV 600V ; pollution degree 2.
2. Safety Precautions
To ensure safe operation of the equipment and eliminate the danger of serious injury due to short-
circuits (arcing), the following safety precautions must be observed. Damages resulting from failure to
observe these safety precautions are exempt from any legal claims whatever.
 Do not exceed the maximum permissible input ratings (danger of serious injury and/or of the
equipment).
 Comply with the safety rules.
 Check test leads and probes for faulty insulations or bare wires before connection to the
equipment.
 Check the proper functioning of the unit before the housework at a known circuit
 Pay special attention when connecting the included flexible current probes on a hedge against
touching the live wires.
 Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or fuse
housing.
 Never touch the tips of test leads or probes.
 Comply with the warning labels and other info on the equipment.
 Conduct measuring works only in dry clothing and in rubber shoes, i. e. on isolating mats.
 Always start with the highest measuring range when measuring unknown values.
 Disconnect test leads or probe from the measuring circuit before switching modes or functions.
 Do not subject the equipment to direct sunlight or extreme temperatures.
 Do not subject the equipment to extreme humidity or dampness.
 Do not subject the equipment to shocks or strong vibrations.
 Keep hot soldering irons or guns away from the equipment.
 Allow the equipment to stabilize at room temperature before taking up measurement (import for
exact measurements).
 Only for indoor-use.
 Measuring instruments don´t belong to children hands
2.1. Safety Symbols
Attention ! Risk of electric shock! Do not open the case during a measuring process!
Attention !
Do not apply over-voltage to the input jacks! Remove the test set cords before opening the battery
compartment! Cleaning - Use a dry cloth to clean the housing! Observe all safety notes in the operating
instructions!
-40-