Datasheet

10.8. Peak Table
Open the Peak Table, you will see the peak list that meets the parameter on the lower portion of
screen (with frequency and amplitude displayed). The table allows 10 peaks to be shown at most.
The opened peak table can be saved in the external memory, also can be recalled when needed.
User can press “Save” key to store the data, detail method is descriped in “Save”.
1. On/Off
Turn on or off the Peak Table, the default is Off.
2. Peak Sort
Set Frequency or Amplitude for peak displayed order, the default is Freq.
3. Peak Readout
Set the display condition to Normal, >DL or <DL.
 Normal
Display the first ten peak value meets with the search parameter in table.
 >DL
Display the first ten peak values meet with the search condition and amplitude beyond display
level.
 <DL
Display the first ten peak values meet with the search condition and amplitude lower than
display level.
11. Marker->
Set the other system parameters (such as frequency, Reference level) using the current marker
reading. Press Marker -> to enable a marker if none of them are active at present.
11.1. Mkr->CF
Set the center frequency of analyzer to be the frequency of current marker.
 If Normal is selected, the center frequency will be set to the frequency of current marker.
 If Delta, Delta Pair, or Span Pair is selected, the center frequency will be set to the frequency
where Delta Marker is.
 In Zero span mode, this function is invalid.
11.2. Mkr->Step
Set the CF step of analyzer to be the frequency of current valid marker.
 If Normal is selected, the CF step will be set to the frequency of current marker.
 If Delta, Delta Pair, or Span Pair is selected, the CF step will be set to the frequency where
Delta Marker is.
 In Zero span mode, this function is invalid.
-37-