Datasheet

Prepare for use
Adjust the legs of the instrument
Open the legs of the Analyzer as bracket of the instrument to make it tilted upward before
operation, which makes the following operation and observation more convenient. When the
instrument is not in use, the user can close the support legs to facilitate placement or removal.
Switching the power on
Connect the Spectrum Analyzer to AC power with the power cord from the accessories, please
refer to the introduction about the requirement of voltage and frequency of AC power in the
“Rear panel” section.
Boot examination
Connect power cord properly, then press the power switch on the front panel to turn on the
Spectrum Analyzer. The boot screen displays the boot initialization process information, then
displays sweep curve at the end.
Perform self-calibration
Please perform self-calibration after boot. Press CAL Calibration Immediate calibration to
process self-calibration for the system with the internal calibration source of the system.
Front panel
① LCD display screen ② Adjusting knob ③Function key area ④ Digit keys
⑤ RF input ⑥Direction keys ⑦ Menu software/ menu control key ⑧USB Host ⑨ Power
Function keys on front panel:
Data
98
7
+dBm
GHz
Search
Peak
Auto
Tune
Single
Display
Trigger
BW
Sweep
Marker
Source
CAL
Setup
System
Recall
Preset
Save
Meas
r
ee
D
t
Trace
cto
Demod
Count
Freq
Marker
AMPT
SPAN
FREQ
dB
Control
Marker
Utility
Setting
-7-