Datasheet

5.39. Set the Gated Burst
Figure 0-22: The User Interface of Gated Burst
1. When the output signal is Sine, Square, Ramp, Pulse or Arbitrary waveform, press
the Mod button, then press F3 to select Burst.
2. Press , , , or button to choose the waveforms. Take
Sine for instance, press to display the waveform and parameters. You can
change the parameters, please refer to “To Set signals” on page 67. Press
button again to return to the Burst mode interface.
3. Press F3 to switch to Gated.
4. Press F2 to select Start Phase, define the Start and the Stop Point in a
waveform. The phase varies from -360° to +360°. For an Arbitrary Waveform, 0° is
the first waveform point.
5. Press F5 to switch between Positive/Negative. Set the Polarity for the Gated
Signal.
5.40. To Save and Recall
Press Save function button to enter the file system.
-89-