Datasheet

12
CH1 Output
Control
Turn on/off the output of CH1. The backlight will be lighted
when CH1 is tuned on.
13
CH1 Output
Output signal of CH1
14
CH1/2 button
Switch channel displayed on the screen between CH1 and
CH2.
15
Modulation (Mod)
Generate the Modulated waveforms, Sweep and Burst;
these functions are only used for CH1.
16
Both button
Display the editable parameters of both channels. When the
function is enabled, the backlight of the button turns on.
17
Waveform
selection buttons
Include: Sine , Square , Ramp , Pulse ,
Noise and Arbitrary waveform. When a
waveform is selected, the backlight of the button turns on.
18
Power button
Turn on/off the generator
4.2. Rear Panel
① ② ⑤ ⑥
⑩ ⑨ ⑧
⑦
③ ④
Figure 0-2 Rear panel overview
1
2
20MHz reference output
20MHz reference input /
Counter input
These two connectors are used to synchronize
generators. The connector [20MHz In/Counter]
accepts an external 20 MHz clock signal, and the
connector [20MHz Out] can output a 20 MHz clock
signal generated by the crystal inside the generator.
(“To set the clock source”; page 96)
The connector [20MHz In/Counter] is also used to
accept the input signal of counter. (“To set the
counter”; page 91)
3
External Trigger
/FSK/Burst
This signal can be used as external signal source in
Sweep, FSK and Burst mode.
-61-