Datasheet

65
12
CH1 Output
Control
Turn on/off the output of CH1. The backlight will be lighted
when CH1 is tuned on.
13
CH1 Output
Output signal of CH1
14
CH1/2 button
Switch channel displayed on the screen between CH1 and
CH2.
15
Modulation (Mod)
Generate the Modulated waveforms, Sweep and Burst;
these functions are only used for CH1. (DC- Button for
P4124)
16
Both button
Display the editable parameters of both channels. When the
function is enabled, the backlight of the button turns on.
17
Waveform
selection buttons
Include: Sine , Square , Ramp , Pulse ,
Noise and Arbitrary waveform. When a
waveform is selected, the backlight of the button turns on.
18
Power button
Turn on/off the generator
4.2. Rear Panel (P 4125 – 4165)
① ② ⑤ ⑥
⑩ ⑨ ⑧
⑦
③ ④
Figure 0-2 Rear panel overview
1
2
20MHz reference output
20MHz reference input /
Counter input
These two connectors are used to synchronize
generators. The connector [20MHz In/Counter]
accepts an external 20 MHz clock signal, and the
connector [20MHz Out] can output a 20 MHz clock
signal generated by the crystal inside the generator.
(“To set the clock source”)
The connector [20MHz In/Counter] is also used to
accept the input signal of counter. (“To set the
counter”)