User Manual

4.3 Basic Operation

4.3.1 To select the output channel

Press 【CHA/CHB】 key to open desired channel configuration screen. Note that fonts of

channel name, mode and waveform were indicated by green color. Use softkeys together

with knob or numeric keypad to set the waveform and parameters of desired channel.

Enable or disable the output signal of desired channel by pressing 【Output】key.

4.3.2 To select a waveform

Press 【Waveform】key to see the first page of the list, and then press 〖More〗softkey to

see the rest of the list. There are sixty waveforms type in total, and select one desired in

sixty to see the waveform diagram under Continuous mode.

4.3.3 To set duty cycle

For example, specify a duty cycle of Square to 20%.

Press 〖Duty Cycle〗 softkey and then set the duty cycle to 20% using the numeric keypad

or the knob and arrow keys 【 <】【 >】. If you use the keypad, press 〖％〗 softkey to finish

entering the value.

4.3.4 To set Frequency

For example, specify a frequency to 2.5kHz.

Press 〖Freq/period〗 softkey and then set the frequency to 2.5kHz using the numeric

keypad or the knob and arrow keys 【 <】【 >】. If you use the keypad, press 〖kHz〗 softkey

to finish entering the value.