User Manual

118
5.15.2 Recall State
Press Status Recallsoftkey and select ‘Recall to recall the state parameters from appointed
non-volatile area. Press Status Recallsoftkey then display 5 memory locations just same as store
state. Press any one of five to recall the relative state. After finishing recall, the display interface
converts to continuous mode and the instrument work under new mode.
5.15.3 Memory
If U-disk is not applied to, ‘Memory’ will display Internal’, which is available for store or recall
operation. While, insert U-disk to USB connector at the front panel, Memory’ will display ‘External’,
indicating that the waveform generator will applied to U-disk to perform store. A file of ‘STATEx.BIN
(x1 to 4) will be created automatically in U-disk during store process, and the instrument state will
be stored in this file.
But in recall operating, the state parameters in the ‘‘STATEx.BIN’ file (x1 to 4) will be recalled to
generator.
With using of U-disk, the operator can save or use the desired working status parameters and both of
storage and recall operation by format BIN.
5.15.4 Language Setting
Press Languagesoftkey to choose Chinese language or English language. The selection is only
available for operate menu and prompt information. The rest sections are always displayed using
English language. If select one language, the generator will always use it and won’t change even if
system reset and power off, unless select language again.
5.16 System Configuration
Press Utilitykey then to System Configursoftkey.