User Manual

107
5.11.1 Set Sweep Signal
In the frequency list mode, the function generator “steps” through the frequencies contained in a list,
dwelling on each frequency for a specified period. The waveform generator can produce a frequency
list sweep for most waveforms mentioned above, but some waveforms are not available.
In some occasion, a frequency list with arbitrary regularity or without any regularity need to be output,
and dwell time on each frequency point can be set, then frequency list sweep will be used.
5.11.2 Frequency List
The length of frequency list can store 600 frequency values with list number 00 to 599. Press 〖List
Number〗softkey and set the desired list number. Then, 〖List Freq〗will be automatically selected and
set the frequency value according to selected list number. Press 〖Next〗softkey can add 1 on list
number and set the following frequency value. Using this method to create or modify a frequency list.
The store and recall of the frequency list are processing with store and recall of instrument state at
the same time, which will be introduced in detail in ‘common operation’.
5.11.3 Start Number and Stop Number
Press 〖Start Number〗or〖Stop Number〗softkey to select the desired number. In the frequency list
sweep mode, the waveform generator moves from the start number, output each frequency value
contained in a list one by one, until to the stop number.
5.11.4 Dwell Time
After enabling sweeps, press 〖Dwell Time〗 softkey. Then use the knob or numeric keypad to enter
the desired dwell time. The dwell time specifies the number of seconds to remain at each frequency
point.