User Manual

5.1.6. FM, AM, PM, PWM:
Carrier waveform: 16 kinds of waveforms including sine, square, ramp, etc. (PWM only for pulse)
Modulation waveform: 16 kinds of waveforms including sine, square, ramp, etc.
Modulation frequency: 40 mHz ~ 20 kHz
Frequency offset: 10 μHz ~ 20 MHz
Modulation amplitude depth: 0%~120％
Phase offset: 0°~360°
Pulse width deviation: 0%~99%
5.1.7. FSK:
Carrier waveform: 16 kinds of waveforms including sine, square, ramp, etc.
Modulation waveform: Square
FSK rate: 40 mHz ~100 kHz
Hop frequency: 10 μHz ~20 MHz
Trigger source: Internal continuous, external signal
5.1.8. Burst:
Waveform: 16 kinds of waveforms including sine, square, ramp
Repeated period: 1 μs ~ 20 s
Pulse count: 1 ~1000000
Start phase: 0°~ 360°
Trigger source: Internal continuous, external signal, manual trigger
5.2. Sync-Output characteristics
5.2.1. Waveform characteristics:
square, edge time≤20 ns
5.2.2. Amplitude characteristics:
compatibility of TTL, CMOS, low level < 0.3 V , high level > 4 V
5.2.3 Programmable interface:
USB device interface, of which the operation guide is on the CD attached with the generator.
5.3. Power amplifier
Maximum output power: 10 W
Maximum output voltage: 22 Vpp
Frequency bandwidth: 100 Hz ~ 10 kHz
5.4. General characteristics
5.4.1. Power conditions:
voltage: 100 ~ 240 V AC
frequency: 45 ~ 65 Hz
power: < 20 VA
5.4.2. Environment conditions:
temperature: 0 ~ 40 °C
humidity: <80% RH
-47-